If new actuator 4302736 are fitted check following setup data:

Hvis der er monteret nye aktuatorer 4302736 kontroller følgende setup data:

Setup parameters, fresh brew:

Position for top piston during brew                                    New default = 2300

Position bottom piston at dreg eject                     New Default = 2475

Max pos for bottom piston during tamper             New Default = 2000

Max current for pistons                                           New Default = 280

Change all recipe with respect to tamper pressure                Recommended = 12

Tamper pressure will always be an individual setting with respect to taste profile.

Expect to adjust grinder a few steps coarser

Make sure firmware in MASTER BOARD = 2019-09-24 or later. This firmware is also compatible with old actuators, just keep the old parameters!

Dear all,

The testing firmware group has been updated to version v3.4.3-3.

Please go to CoffeeCloud > Machine Settings > Firmware.

Change from ‘Stable’ to ‘Testing’ to have the machine download a testing firmware. Testing firmware group will be updated regularly with new versions, and we will announce 24 hours before update.

Please start to perform test on a number of machines in your market. If you are experiencing issues, please report back to support@scanomat.com
As always, if auto-update parameter is turned ON and machine is online , the firmware will automatically download and apply the test firmware to machine. 

You can in the Overview section on CoffeeCloud see which firmware version a machine is running.

It can take up to one hour in CoffeeCloud to show correct data, after firmware has been applied.

Changelog

Added

• An option to require online connectivity, defined by communication with CoffeeCloud. If communication with CoffeeCloud is blocked, the machine will raise the error “Needs online”.

Fixed

• Bug that made it possible to brew a coffee while being cold.
• Erroneous bean hopper 1 empty alarm.
• Bug that sometimes skipped resetting hours since clean to zero, when clean is successfully completed.
• Minor display symbol.

Best regards

Scanomat R&D

Jamie and Chris test – please reply if you see this

Test post for Jamie and Chris. Please reply if you receive!

Please reply if you receive (and are part of Scanomat UK, else please discard)